Epinox San-10 Cream Dispenser, 1000 ml

SET CONTENT

• Aluminum bottle
  
• Aluminum Head
• 3-piece decoration nozzle
• Decoration nozzle cleaning brush
• Protection cap
• Tube holder

USAGE INSTRUCTIONS

• If using the cream dispenser for the first time or after a long period, wash the bottle first with warm, then with cold water.
  
• Fill the bottle with well-cooled fresh cream or other ingredients according to your recipe. Do not overfill the bottle beyond the marked capacity. Ensure that all solid ingredients are completely dissolved before filling into the bottle to prevent clogging.
  
• Place the gasket on the head and securely close the head by turning it onto the bottle. If no thread is visible on the bottle, the cap is properly closed. Do not cross-thread.
• Insert the cream tube (8g N2O) into the tube holder. It is recommended to use original tubes, but you can also use 8g N20 tubes with Liss or ISI standards.
• Attach the tube holder to the valve by twisting until a hissing sound is heard. Use 1 tube for each fill. Shake the bottle four to five times upright. When using well-cooled light cream or another mixture, shake up to ten times, loosen the tube holder and the tube. The slight hissing sound heard during loosening is normal. Remove the metal tube. These tubes can be used as scrap and are recyclable.
• For dispensing, hold the bottle upright with the decoration nozzle facing down. There should be approximately 1 cm distance between the nozzle and the surface you will squeeze the cream onto. Gently press the trigger, if the cream is not firm enough, shake the bottle once more. Do not shake again while continuing to use.

MAINTENANCE INSTRUCTIONS

• Do not use sharp or abrasive objects to clean the bottle.
  
• Do not place the cream dispenser in the freezer or deep freeze.
• Do not expose the cream dispenser to heat (stove, sun, microwave, etc.).
• Only open the cream dispenser when the pressure is completely released. Press the trigger until the hissing sound stops.
• During cleaning, only remove the parts specified in the maintenance instructions.
• All parts can be easily assembled. Therefore, there is no need to use force.
• For your safety, do not lean over the product during operation.
• Blockages may occur in the valve due to filling the bottle with solid ingredients. In such cases, follow this procedure: Do not attempt to remove the head! Place the bottle on the counter and wait for the contents to settle at the bottom. Then cover the head with a thick cloth and press the trigger several times until the gas is completely released. If you still cannot loosen the head, contact the company you purchased the product from.
• Note: Use only original spare parts!Never use the product's parts with other products or similar products from other manufacturers.
• Do not attempt to make modifications to the product.
  
• If possible, use original tubes.
• The dispenser and tubes are pressurized products, care and attention are required when using them.
• Never use the product in a damaged state.
  
• Keep the dispenser and tubes out of reach of children.
• The cream dispenser can only be used for the preparation of cream and similar liquid products.
  
• Keep this instruction booklet.